ti8168 原始文件系统进去后没有网络eth0接口,为了有该接口须要配置/etc/network/interfaces 文件

详细配置例如以下(红色要配置)

# /etc/network/interfaces -- configuration file for ifup(8), ifdown(8)

 

# The loopback interface

auto lo

iface lo inet loopback

# Wireless interfaces

#

# Example of an unencrypted (no WEP or WPA) wireless connection

# that connects to any available access point:

#

iface wlan0 inet dhcp

        wireless_mode managed

        wireless_essid any

#

#

# Same as above but locked to a specific access point:

#

#iface wlan0 inet dhcp 

#       wireless_mode managed

#       wireless-essid some-essid

#

# A WEP encrypted connection locked to a specific access point:

#

#iface wlan0 inet dhcp 

#       wireless-essid some-essid

#       wireless-key s:My-PlainText-Password

#       wireless-mode managed                 

#

# A WPA1 or WPA2 encrypted connection locked to a specific access point.

# This is the best option for non-roaming, single-network usage.

# Note that your card may require a firmware update to use WPA.

# Some distributions install a temporary volatile firmware update on ifup.

#

#iface wlan0 inet dhcp                                                  

#       wpa-essid some-essid                                         

#       wpa-psk My-PlainText-Password                                             


#

# A WPA1 or WPA2 encrypted connection using an external configuration file

# for wpa-supplicant. This is the way to go if you need to configure multiple

# networks with different keys and / or WPA settings and roaming support.

#

# iface wlan0 inet dhcp

#    wpa-conf /etc/wpa_supplicant.conf

#    wpa-driver hostap

iface atml0 inet dhcp

# Wired or wireless interfaces

auto eth0

iface eth0 inet dhcp

        pre-up /bin/grep -v -e "ip=[0-9]\+\.[0-9]\+\.[0-9]\+\.[0-9]\+" /proc/cmdline > /dev/null

iface eth1 inet dhcp

# Ethernet/RNDIS gadget (g_ether)

# ... or on host side, usbnet and random hwaddr

iface usb0 inet static

        address 192.168.0.202

        netmask 255.255.255.0

        network 192.168.0.0

        gateway 192.168.0.200

# Zaurus 2.4 Lineo net_fd; obsolete

iface usbd0 inet static

        address 192.168.129.201

        netmask 255.255.255.0

        network 192.168.129.0

        gateway 192.168.129.200

# iPAQ 2.4 mach-sa1100/usb-eth

# (192.168.0.202 is the iPAQ's IP, 192.168.0.200 is the host's IP)

iface usbf inet static

        address 192.168.0.202

        netmask 255.255.255.0

        network 192.168.0.0

        gateway 192.168.0.200

# Bluetooth networking

iface bnep0 inet dhcp

ifconfig eth0 MTU 9000

05-11 12:56