本文介绍了Git权限被拒绝(公钥)的处理方法，对大家解决问题具有一定的参考价值，需要的朋友们下面随着小编来一起学习吧！
问题描述
我已经为我的网络驱动器创建了ssh密钥.唯一的问题是，当无法访问网络驱动器时，由于未找到ssh密钥，我的git pull/push无法正常工作.因此，我决定向Windows驱动器添加新密钥.我添加了新的ssh密钥，但是当我拉/推代码时收到以下错误消息
I already have created the ssh key to my network drive. Only issue is that when network drive is not accessible then my git pull/push not worked due to no ssh key found. So I decided to add new key to my windows drive.I added the the new ssh key but when I pull/push code I received below error
Permission denied (publickey).
fatal: Could not read from remote repository.
Please make sure you have the correct access rights
and the repository exists.
然后我在命令下运行
1) $ eval `ssh-agent`
2) ssh-add /d/ssh/id_rsa
之后，我可以拉/推.但是再次出现问题，每当我重新启动计算机时，我都需要运行那两个命令.这不是每次都运行的好方法.那么有什么好的解决方法，所以我不需要运行命令.
After that I am able to pull/push. But again there is problem whenever I restart my computer I need to run that 2 commands. This is not good solution to run every time. So is there any good solution so that I no need to run command.
注意:我已经从网络驱动器中删除了所有以前的ssh密钥.
Note: I already deleted all the previous ssh key from my network drive.
已更新
运行ssh -vvv bitbucket.org命令后，输出如下.
After I run ssh -vvv bitbucket.org command the output is below.
OpenSSH_7.1p2, OpenSSL 1.0.2h 3 May 2016
debug1: Reading configuration data /etc/ssh/ssh_config
debug2: ssh_connect: needpriv 0
debug1: Connecting to bitbucket.org [104.192.143.1] port 22.
debug1: Connection established.
debug1: key_load_public: No such file or directory
debug1: identity file /z/.ssh/id_rsa type -1
debug1: key_load_public: No such file or directory
debug1: identity file /z/.ssh/id_rsa-cert type -1
debug1: key_load_public: No such file or directory
debug1: identity file /z/.ssh/id_dsa type -1
debug1: key_load_public: No such file or directory
debug1: identity file /z/.ssh/id_dsa-cert type -1
debug1: key_load_public: No such file or directory
debug1: identity file /z/.ssh/id_ecdsa type -1
debug1: key_load_public: No such file or directory
debug1: identity file /z/.ssh/id_ecdsa-cert type -1
debug1: key_load_public: No such file or directory
debug1: identity file /z/.ssh/id_ed25519 type -1
debug1: key_load_public: No such file or directory
debug1: identity file /z/.ssh/id_ed25519-cert type -1
debug1: Enabling compatibility mode for protocol 2.0
debug1: Local version string SSH-2.0-OpenSSH_7.1
debug1: Remote protocol version 2.0, remote software version OpenSSH_6.4
debug1: match: OpenSSH_6.4 pat OpenSSH* compat 0x04000000
debug2: fd 3 setting O_NONBLOCK
debug1: Authenticating to bitbucket.org:22 as 'Azam.Alvi'
debug3: hostkeys_foreach: reading file "/z/.ssh/known_hosts"
debug3: record_hostkey: found key type RSA in file /z/.ssh/known_hosts:1
debug3: load_hostkeys: loaded 1 keys from bitbucket.org
debug3: order_hostkeyalgs: prefer hostkeyalgs: [email protected],ssh-rsa
debug1: SSH2_MSG_KEXINIT sent
debug1: SSH2_MSG_KEXINIT received
debug2: kex_parse_kexinit: [email protected],ecdh-sha2-nistp256,ecdh-sha2-nistp384,ecdh-sha2-nistp521,diffie-hellman-group-exchange-sha256,diffie-hellman-group-exchange-sha1,diffie-hellman-group14-sha1
debug2: kex_parse_kexinit: [email protected],ssh-rsa,[email protected],[email protected],[email protected],[email protected],ecdsa-sha2-nistp256,ecdsa-sha2-nistp384,ecdsa-sha2-nistp521,ssh-ed25519
debug2: kex_parse_kexinit: [email protected],aes128-ctr,aes192-ctr,aes256-ctr,[email protected],[email protected],arcfour256,arcfour128,aes128-cbc,3des-cbc,blowfish-cbc,cast128-cbc,aes192-cbc,aes256-cbc,arcfour,[email protected]
debug2: kex_parse_kexinit: [email protected],aes128-ctr,aes192-ctr,aes256-ctr,[email protected],[email protected],arcfour256,arcfour128,aes128-cbc,3des-cbc,blowfish-cbc,cast128-cbc,aes192-cbc,aes256-cbc,arcfour,[email protected]
debug2: kex_parse_kexinit: [email protected],[email protected],[email protected],[email protected],[email protected],[email protected],[email protected],hmac-sha2-256,hmac-sha2-512,hmac-sha1,[email protected],[email protected],[email protected],[email protected],hmac-md5,hmac-ripemd160,[email protected],hmac-sha1-96,hmac-md5-96
debug2: kex_parse_kexinit: [email protected],[email protected],[email protected],[email protected],[email protected],[email protected],[email protected],hmac-sha2-256,hmac-sha2-512,hmac-sha1,[email protected],[email protected],[email protected],[email protected],hmac-md5,hmac-ripemd160,[email protected],hmac-sha1-96,hmac-md5-96
debug2: kex_parse_kexinit: none,[email protected],zlib
debug2: kex_parse_kexinit: none,[email protected],zlib
debug2: kex_parse_kexinit:
debug2: kex_parse_kexinit:
debug2: first_kex_follows 0
debug2: reserved 0
debug2: kex_parse_kexinit: ecdh-sha2-nistp256,ecdh-sha2-nistp384,ecdh-sha2-nistp521,diffie-hellman-group-exchange-sha256,diffie-hellman-group-exchange-sha1,diffie-hellman-group14-sha1,diffie-hellman-group1-sha1
debug2: kex_parse_kexinit: ssh-dss,ssh-rsa
debug2: kex_parse_kexinit: aes128-ctr,aes192-ctr,aes256-ctr,arcfour256,arcfour128,[email protected],[email protected],aes128-cbc,3des-cbc,blowfish-cbc,cast128-cbc,aes192-cbc,aes256-cbc,arcfour,[email protected]
debug2: kex_parse_kexinit: aes128-ctr,aes192-ctr,aes256-ctr,arcfour256,arcfour128,[email protected],[email protected],aes128-cbc,3des-cbc,blowfish-cbc,cast128-cbc,aes192-cbc,aes256-cbc,arcfour,[email protected]
debug2: kex_parse_kexinit: [email protected],[email protected],[email protected],[email protected],[email protected],[email protected],[email protected],[email protected],[email protected],hmac-md5,hmac-sha1,[email protected],[email protected],hmac-sha2-256,hmac-sha2-512,hmac-ripemd160,[email protected],hmac-sha1-96,hmac-md5-96
debug2: kex_parse_kexinit: [email protected],[email protected],[email protected],[email protected],[email protected],[email protected],[email protected],[email protected],[email protected],hmac-md5,hmac-sha1,[email protected],[email protected],hmac-sha2-256,hmac-sha2-512,hmac-ripemd160,[email protected],hmac-sha1-96,hmac-md5-96
debug2: kex_parse_kexinit: none,[email protected]
debug2: kex_parse_kexinit: none,[email protected]
debug2: kex_parse_kexinit:
debug2: kex_parse_kexinit:
debug2: first_kex_follows 0
debug2: reserved 0
debug1: kex: server->client aes128-ctr [email protected] none
debug1: kex: client->server aes128-ctr [email protected] none
debug1: sending SSH2_MSG_KEX_ECDH_INIT
debug1: expecting SSH2_MSG_KEX_ECDH_REPLY
debug1: Server host key: ssh-rsa SHA256:zzXQOXSRBEiUtuE8AikJYKwbHaYXaGp1A
debug3: hostkeys_foreach: reading file "/z/.ssh/known_hosts"
debug3: record_hostkey: found key type RSA in file /z/.ssh/known_hosts:1
debug3: load_hostkeys: loaded 1 keys from bitbucket.org
debug3: hostkeys_foreach: reading file "/z/.ssh/known_hosts"
debug3: record_hostkey: found key type RSA in file /z/.ssh/known_hosts:1
debug3: load_hostkeys: loaded 1 keys from 104.192.143.1
debug1: Host 'bitbucket.org' is known and matches the RSA host key.
debug1: Found key in /z/.ssh/known_hosts:1
debug2: set_newkeys: mode 1
debug1: SSH2_MSG_NEWKEYS sent
debug1: expecting SSH2_MSG_NEWKEYS
debug2: set_newkeys: mode 0
debug1: SSH2_MSG_NEWKEYS received
debug1: SSH2_MSG_SERVICE_REQUEST sent
debug2: service_accept: ssh-userauth
debug1: SSH2_MSG_SERVICE_ACCEPT received
debug2: key: /d/ssh/id_rsa (0x600072470),
debug2: key: /z/.ssh/id_rsa (0x0),
debug2: key: /z/.ssh/id_dsa (0x0),
debug2: key: /z/.ssh/id_ecdsa (0x0),
debug2: key: /z/.ssh/id_ed25519 (0x0),
debug1: Authentications that can continue: publickey
debug3: start over, passed a different list publickey
debug3: preferred publickey,keyboard-interactive,password
debug3: authmethod_lookup publickey
debug3: remaining preferred: keyboard-interactive,password
debug3: authmethod_is_enabled publickey
debug1: Next authentication method: publickey
debug1: Offering RSA public key: /d/ssh/id_rsa
debug3: send_pubkey_test
debug2: we sent a publickey packet, wait for reply
debug1: Authentications that can continue: publickey
debug1: Trying private key: /z/.ssh/id_rsa
debug3: no such identity: /z/.ssh/id_rsa: No such file or directory
debug1: Trying private key: /z/.ssh/id_dsa
debug3: no such identity: /z/.ssh/id_dsa: No such file or directory
debug1: Trying private key: /z/.ssh/id_ecdsa
debug3: no such identity: /z/.ssh/id_ecdsa: No such file or directory
debug1: Trying private key: /z/.ssh/id_ed25519
debug3: no such identity: /z/.ssh/id_ed25519: No such file or directory
debug2: we did not send a packet, disable method
debug1: No more authentication methods to try.
Permission denied (publickey).
推荐答案
使用
Host git_hostname # probably bitbucket.org
IdentityFile /d/ssh/id_rsa
它应该在~/.ssh/config中.您应该能够找出运行ssh -vvv bitbucket.org时客户端读取的配置.
It should be in ~/.ssh/config. You should be able to find out what configuration is your client reading when running ssh -vvv bitbucket.org.
这篇关于Git权限被拒绝(公钥)的文章就介绍到这了，希望我们推荐的答案对大家有所帮助，也希望大家多多支持！