建立两个vlan,把一二口划入vlan1,三四口划入vlan2
Switch>enable
Switch#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Switch(config)#int vlan 1
Switch(config-if)#ip address 192.168.0.1 255.255.255.0
Switch(config-if)#no shut
Switch(config-if)#vlan 2
Switch(config-vlan)#int vlan 2
Switch(config-if)#ip address 192.168.1.1 255.255.255.0
Switch(config-if)#no shut
Switch(config-if)#int f0/1
Switch(config-if)#switchport access vlan 1
Switch(config-if)#int f0/2
Switch(config-if)#switchport access vlan 1
Switch(config-if)#int range f0/3-4
Switch(config-if-range)#switchport access vlan 2
Switch(config-if-range)#exit
09-13 08:24